Simrad AP28 Información técnica descargar pdf (Pagina 81)

Setup at installation | 79

Compass calibration

Before the compass calibration is started, make sure that

there is enough open water around the vessel to make a

full turn.

The calibration should be done in calm sea conditions and

with minimal wind to obtain good results. Use about 60-

90 seconds to make a full circle.

1. Highlight the Calibrate line in the dialog

2. Begin turning the boat to port or starboard

3. Press the MENU key to start the automatic compass

calibration

a. An information window will be

displayed when the calibration

procedure is running.

b. The digits below the bargraph will

read 0.0 when the turn rate is

correct. Too high or too low turn

rate is indicated as follows (For

RC42 Rate Compass only!):

Turn rate too high,

turning cw

Turn rate too low,

turning cw

4. The automatic calibration is completed when the

information window disappears from the display

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 123 124

Sin comentarios

Simrad AP28 Información técnica Pagina 81