Simrad NSS Guía de instalación descargar pdf (Pagina 17)

Wiring the NSS | NSS Installation Manual

Wiring the NSS

Wiring guidelines

Don’t do this Do this

Don’t make sharp bends in the cables Do make drip and service loops

Don’t run cables in a way that allows water

to  ow down into the connectors

Do tie-wrap all cables to keep them secure

Don’t route the data cables in areas adjacent

to radar, transmitter, or large current carrying

cables

If cables are shortened, lengthened, or

re-terminated, do insulate and protect all

wiring connections

Do leave room at the back to install and

remove cables

Warning: Before starting the installation, be sure to turn electrical power o . If power is

left on or turned on during the installation,  re, electrical shock, or other serious injury may

occur. Be sure that the voltage of the power supply is compatible with the NSS display

Warning: The NSS has a voltage rating of 12 V DC or 24 V DC. (9 V DC - 32 V DC max

range). SimNet is 12 V DC only

Warning: The red wire should always be connected to (+) DC V using a fuse or thermal

breaker (10 Amp)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 65 66

Sin comentarios

Simrad NSS Guía de instalación Pagina 17