Simrad PI54 A Especificaciones descargar pdf (Pagina 261)

PI Configurator

249

850-165186 / Rev.B

LED Control

This parameter can only be accessed in the Professional mode.

The dialogue box is used to control the behaviour of the

interfaced sensor’s internal LED during normal operation. LED

behaviour in both the charge and communication modes can not

be altered. Sensor LED parameters are:

• Startup Only - The LED will only illuminate (flashing its

identification code) when it is energized. It will not be turned

on during normal operation.

• Only when P inging - The LED will only illuminate when it

“pings” (transmits data).

• When <2m - The LED will flash every time the sensor

“pings”, but only when it is at a depth of less than two

meters. This parameter is only available for depth sensors.

• Always - If the sensor is disabled from pinging at depths less

than two meters by the Ping Control parameter being set to

Depth > 2m,theAlways parameter causes the sensor’s LED

to illuminate at depths of less than two meters even when the

sensor does not “ping”.

Operation

To operate, use the LED Control spin button to select the

desired LED behaviour. Then, click the Configure Sensor

button to program the interfaced sensor with the new parameter.

Finally, check that the message field is updated with the new

parameter, and that the message Success!! is displayed at the

bottom as confirmation that the command was executed.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 321 322

Sin comentarios

Simrad PI54 A Especificaciones Pagina 261