Simrad PI REMOTE - REV A Manual de instrucciones

Instruction manualSimrad PI Remote/DepthSensor for depth and spread measurementsTECHNOLOGY FOR SUSTAINABLE FISHERIESwww.simrad.com(CD012201F)

Simrad PI Remote/DepthINSTALLATIONThe PI Remote/Depth sensor is mounted on the starboardtrawl door using a special adapter. From this position, it wil

InstallationInstallation principlesObserve the installation principles in the illustration.Figure 4 Installation principles(CD012200K)ABCEFD(A) The PI

Simrad PI Remote/DepthCONFIGURATIONIn order to allow the information from the PI Remote/Depthsensor to be accepted and understood by the PI c atch mon

ConfigurationWe recommend that you use the form at the beginning of thePI32 Operator manual to write down the sensors you have andtheir respective comm

Simrad PI Remote/DepthNoteIn order to set up the PI system you must know what kind ofsensors you have, which communication channels they use, andhow o

ConfigurationAll sensors are provided with default communication channelsand update rates. Refer to the table in section About sensorconfiguration on pa

Simrad PI Remote/Depth1 To reset the unit, set all six sensors to default sensor typeNone.2 Choose the sensor you wish to use for the PI Spread/Depths

ConfigurationTable 1 Default communication channels and update rates (cont’d.)Sensor Com.channel(s)Update ratePI Temperature 8 FastPI SeineSounderDepth

Simrad PI Remote/DepthAll sensors are provided from Simrad with a default update ratesetting. In some cases you may find that this update rate does not

Display presentationsDISPLAY PRESENTATIONSThe information provided by the PI Remote/Depth sensor isshown on the PI catch monitoring system’s colour di

Simrad PI Remote/DepthFigure 9 Graphical presentation on PI32C345.9D1mS2m025507510010155(CD012102D)25.6This example shows how the trawl door is locate

Display presentations• Marker line delay: The echo sounder information isprovided by the transducer located below the vessel’shull. The sensor is howe

Simrad PI Remote/DepthFigure 10 Graphical presentation on PI44/PI5417.5 12.5107.552.515min38kHz 1000W MEDIUMT 22.5 CoS 7.2kn DK 1050 m(CD012106F)D1[m]

Display presentations• Use this parameter to control the thickness (in pixels)of the marker line(s).8 For every marker line, setShow to On.9 If you wi

Simrad PI Remote/Depthright side of the display, or the read-out in the numeric display. Ifthe trawl door distance is reduced or increased, this will

Charging and maintenanceCHARGING AND MAINTENANCEThis chapter explains how you shall recharge the battery in thePI Remote/Depth sensor, and how you sha

Simrad PI Remote/DepthPI Remote/Depth chargingThe PI Remote/Depth sensor must be charged between operation.The battery lifetime depends on the update

Charging and maintenanceHow to use the Simrad P I ChargerThe Simrad PI Charger is an intelligent battery charger forfast and secure charging of the PI

Simrad PI Remote/Depth• This may be ropes, wires, chains or other items thatobstruct or short circuit the electrical connections.3 When the charger is

Charging and maintenanceABC(C) Battery temperature indicators during fast charging of PIsensors:• Green: Battery temperature between +5 and +40°C. Fas

Simrad PI Remote/DepthInstruction manualThis document gives you the necessary information formounting, charging and maintaining the PI Remote/Depthsen

Simrad PI Remote/DepthHowtousetheSimradPIMaxiChargerThe Simrad PI MaxiCharger is a plain battery charger to be usedwith large PI sensors.Figure 12 Sim

Charging and maintenance4 When the charger is connected to the sensor, check thecharger lamps.• After a few seconds, the lamp on the charger will chan

Simrad PI Remote/DepthAApplications, 5CCharging, 2 3–2 4Communicationchanneldefault values, 14why change?, 15Configuration, 10PI32, 10PI44, 11PI54, 11R

ISBN-10: 82-8066-096-8ISBN-13: 978-82-8066-096-1©2007 Kongsberg Maritime ASKongsberg Maritime ASStrandpromenaden 50P. O . B o x 1 1 1N-3191 Horten, No

Document historyDocument number: 316870 / ISBN-1 0: 82-8066-096-8 / ISBN-13: 978-82-8066-096-1Rev.A19 November 2007 First release.Copyright©2007 Kongs

Instruction manualTable of contentsINTRODUCTION ... 5Purpose a nd applications...

Simrad PI Remote/Depth4316870/A

IntroductionINTRODUCTIONEfficient fishery with trawl and purse seine assumes professionaland adequate instrumentation on the gear. Simrad has providedpr

Simrad PI Remote/DepthThe PI Remote/Depth thus contains both a pressure sensor tomeasure the water depth, and a transducer to communicate withthe PI S

IntroductionInformation on the sensor labelThe sensor label provides the following information.Figure 3 The PI Remote/Depth sensor labelBD(CD012201D)A